Blowpipe
Syringes (Click
on Thumbnails to view larger images)
Telinject blowpipe syringes are constructed of a very lightweight,
durable clear plastic. Although specified as 1, 2, 3, and 5 ml syringes,
each size has an actual capacity of (approximately) additional 1/2
ml. Syringes are available in packages of 5 or 10 and can be supplied
as followed:
1
ml, 2 ml, 3 ml Syringes: 1 ml, 2 ml, 3 ml, with the
orange tailpieces for use with 11 mm i.d. blowpipes of 1 or 2 meters
in length.
High
Performance 5 ml Syringe: 5 ml Syringes: 5ml, with yellow-red tailpieces, for use only with the 14mm and 16mm blowpipes.
Telinject
Syringe with Plastic Stabilizer: 1 ml thru 5 ml syringes
utilize the orange plastic tailpiece for use in the High Performance
blowpipe. It is recommended that you use the Vario needles in the
High Performance blowpipe.
Stabilizers
(Tailpieces) can also be bought separately.
Blowpipe
Needles (Click
on Thumbnails to view larger images)
Telinject special cannules
(Needles) for use on Telinject blowpipe syringes are available in 3 different
gauges and 4 sizes. The smallest are 0.9 X 25 mm and largest are 1.2 x
38 mm. These needles are standard, high quality hypodermic needles modified
by Telinject for use with the blowpipe syringe. The needles have a soldered,
sharp point. The exit hole, for any liquid used with the syringe, is on
the side of the needle near the tip. The silicone sleeves for blowpipe
needles are white and contain a bored center thru which the needle is
passed. The silicone sleeves, supplied with the needles, are placed over
this exit hole prior to seating the needle into the syringe. The various
sizes for needles in the size classes are listed below. Blowpipe needles
are available in packages of 5 or 10. We provide 15 silicone sleeves with
each order of 5 needles, and 30 for each order of 10 needles.
0.9
x 25 mm, Plain (20 gauge x 1") For
small sized dogs, monkeys, small antelope, fawns, bobcats, ocelots margays,
lynx, domestic cats, raccoons, small marsupials, skunks and ferrets
1.1
x 30 mm, Plain (19 gauge x 1-1/4") For
medium sized dogs, baboons, deer, mountain lions, jaguars, leopards, medium
sized marsupials, rheas, emus.
1.1
x 38 mm, Plain (19 gauge x 1-1/2") For larger dogs,
horses, cattle, chimpanzees, gorillas, lions, tigers, kangaroos, elk,
red deer, large antelope, zebras, ostrich, cassowaries.
1.2
x 38 mm Plain (18 gauge x 1-1/2") For large antelope,
bulls, non-domestic horses, moose, elephants, rhinos, bears.
Safety
Caps For Blowpipe Needles: These plastic, closed end,
poly nylon tubes are placed over the medicine chamber of the syringe while
it is being pressurized. In the event that a silicone sleeve should leak
and allow a liquid to escape around it, the safety cap will prevent the
liquid from being discharged onto the user of the syringe or other individuals
who are in the near vicinity of the syringes while it is being pressurized.
Available in for all sizes and gauges of Blowpipe Syringes.
IT
IS EXTREMELY IMPORTANT TO PLACE A SAFETY CAP OVER THE LOADED SYRINGE DURING
THE PRESSURIZATION PROCESS. Many drugs used as sedatives or immobilizing
agents can cause sickness and even death of an individual if the operator
is sprayed in the face/eyes and mouth.
White Silicone Sleeves For Blowpipe Needles can also be bought separately.
Filler
Syringes: These are standard,
hypodermic syringes used with a connector to load liquids into the front
chamber of the syringe and to charge the rear chamber of the syringe with
air.
Required sizes: For liquid instillation - 1, 3, 6 cc's
For air instillation -12 & 20 cc's
THE BLOWPIPE SYRINGES AND NEEDLES CANNOT BE UTILIZED WITH THE TELINJECT, VARIO PISTOLS AND RIFLES. TELINJECT USA INC.'S WARRANTY OF THESE SYRINGES DOES NOT APPLY TO BLOWPIPE SYRINGES/NEEDLES USED WITH THE TELINJECT PISTOLS AND/OR RIFLES.
TELINJECT
USA, INC.
Remote Injection Equipment
Copyright
© Telinject USA, Inc.
All
rights reserved.